Jotul GI 450 DV Katahdin Gas Insert Replacement Blower
This Blower Kit is for Jotul GI 450 DV gas inserts models with a serial number between 0001 and 4627 ONLY, this blower does not have a Bypass switch
The GI 450 DV Katahdin is equipped with a 125 cfm heat-activated blower. A ten foot power cord is in- stalled in the rear of the valve compartment under the firebox.
Open the Lower Grill and fully unwrap the power cord. The cord can exit either the right or left side of the insert. Be sure to pull all slack out of the power cord to prevent contact with the bottom of the firebox.The is equipped with a three-prong (grounding) plug for protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. DO NOT CUT OR REMOVE THE GROUNDING PRONG FROM THE PLUG.
The blower must be electrically grounded in accordance with local codes or, in the absence of local codes, with the current NFPA 70- National Electrical Code or CSA C22.1-Canadian Code.
The blower is controlled by a heat activated switch (snapstat) that will function only if the blower control switch is in the AUTO setting. Once the firebox heats after the burner has been operating for a short time,
the blower will start on either the HI or LOW speed. In AUTO mode, the blower will continue to operate after the burner is turned off, until the snapstat cools. See fig. 18. If blower operation is not desired, place the control
switch in the OFF position to bypass the snapstat function