Product Description
Jotul 153701 Nickel Door Handle Kit
Part #153701
Designed for the Jotul:
F 3 CB Wood Stove
F 400 Castine Wood Stove with Single Door
Before removing the old door handle please take a picture of how the door latch bolt on the inside of the stove is orientated to the cast iron door crank on the outside of the door.
To remove your old door handle you must cut the latch bolt shaft with a hack saw on the inside of the door.
To install the new door handle assemble the handle with the latch bolt on the inside of the door pointing to 9 O'clock and the washer, spring and cast iron crank on the outside of the door with the cast iron crank pointing 6 O'clock.
Once your sure about the alignment insert the roll pin into the cast iron crank and tap in with hammer, This step is irreversible so make sure you have it were you want it before taping the pin into the crank.
Once the handle is installed you can then install the wood knob by inserting the bolt and sleeve into the wood knob with the fiber washer positioned between the wood knob and the cast crank.
Using a screw driver tighten the screw while holding the washer and nut on the back side of the cast crank.
Designed for the Jotul:
F 3 CB Wood Stove
F 400 Castine Wood Stove with Single Door
Before removing the old door handle please take a picture of how the door latch bolt on the inside of the stove is orientated to the cast iron door crank on the outside of the door.
To remove your old door handle you must cut the latch bolt shaft with a hack saw on the inside of the door.
To install the new door handle assemble the handle with the latch bolt on the inside of the door pointing to 9 O'clock and the washer, spring and cast iron crank on the outside of the door with the cast iron crank pointing 6 O'clock.
Once your sure about the alignment insert the roll pin into the cast iron crank and tap in with hammer, This step is irreversible so make sure you have it were you want it before taping the pin into the crank.
Once the handle is installed you can then install the wood knob by inserting the bolt and sleeve into the wood knob with the fiber washer positioned between the wood knob and the cast crank.
Using a screw driver tighten the screw while holding the washer and nut on the back side of the cast crank.
