Product Description
Hearthstone Clydesdale 8491 Rheostat Fan Speed Control
7200-601
For use in the below Models of Hearthstone Stoves:
- Hearthstone Clydesdale 8491
- Hearthstone Clydesdale 8492
THIS IS NOT A EASY TO REPLACE PART, please see below
Disconnect the BLOWER from any source of power when removing or servicing it in any way. Only work on a cold stove.
1. The blower assembly is factory installed in the ash lip assembly. To replace the blowers or any other parts of the blower system it is necessary to remove the ash lip cover, façade, and the ash lip assembly. Locate the hex socket head set screws on the front left and right side of the ash lip housing. Loosen, but do not remove the screws, then lift the front edge of the ash lip cover up, and slide it out and away from the insert..
2. Remove the top grill and façade to provide access to the ash lip assembly mounting flanges and the blower mounting screws.
3. Remove screw and step bushing securing the primary air control to the motor control bracket.
4. Use a 1/2” socket, or wrench and remove the 4 bolts and washers securing the ash lip assembly to the body of the insert. There is no need to disconnect any wires at this time.
5. Use a Phillips head screwdriver to remove the 2 screws securing the wire loops holding the power cord. Remove the 4 screws securing the speed control bracket and ground wires to the front assembly. Remove the notched wheel from the speed control, and retain. Retain the screws and loops for installation of the new blower controller
6. Reverse above step to reassemble
